Crashing routed on 1100 Appliances (continued) [UPDATED]

More than a month ago I published this article about a crashing routed on two 1100 appliances when just entering the command ‘show route’ in CLISH.

It took some very long time to get an answer from R&D and apparently they could not reproduce the whole thing. They were able to crash routed but the failover could not be reproduced. After sending some more debug information and further investigation by R&D I was asked to enter two commands in CLISH.

Continue reading “Crashing routed on 1100 Appliances (continued) [UPDATED]”

Crashing routed on 1100 Appliances

Probably a few weeks ago I was asked to take a look at a Check Point  1100 cluster with Gaia Embedded R77.20.31 on it which had one member with a Down status. This is not a production cluster so when a reboot solved the problem we did not spend more time to investigate this issue deeper. Until then this only happened once.

But yesterday it happened again…

Continue reading “Crashing routed on 1100 Appliances”